Motorcycle Blind Spot Monitoring System IP67 Waterproof 24Ghz Millimeter Wave Sensor Lane Change Assist System Moto Safe Driving
Features:
Motorcycle Blind Spot Detection System. The product is composed of one 24Ghz microwave radar sensor, two indicators, one mounting bracket and connecting harness.
This product can give early warning to dangerous targets in the left and right rear of motorcycle, 24Ghz microwave radar Its unique capacities of penetrating the smoke, fog and dust can realize the all-weather and all-time application,It is able to detect the target as far as 15 meters(49.21ft) at maximum, and finally output the warning signals. The warning signals include the light always on and light flashes.
Packing List: 1x 24GHZ microwave radar. 2x Warning light. 1x Power cable. 1x Mounting bracket. 1x User manual.
Specifications:
Type: Motorcycle Blind Spot Monitoring System
Working voltage: 10 V-36 V
Working frequency: 24 Ghz
Signal angle: ±60°
Working temp:-40°C to + 85°C(-40°F to 185°F)
Power consumption: <5W
Water-proof level: IP67
Antenna: single sending and single receiving
Early warning range horizontal: 0.2 to 4M, vertical 0 to 15M.
Early warning speed range: 0KM/H-120KM/H(0 mile/H-74.56 miles/H)
Distance resolution: 0.4M
Detection distance: 15M
Power cord connection method:
1.Connect the red wire of the power cord to the motorcycle's ACC power supply (normal power when the car is started/out of power), and connect the black wire of the power cord to the negative pole of the motorcycle or ground.
2.The connection method of the radar line: the radar line plug and the power line plug are inserted into each other.
3.Warning light connection method: the warning light plug corresponds to the warning light plug on the power cord, and the left and right are distinguished and the warning light is fixed to a prominent driving posture near the instrument.
Radar installation method:
1.Radar installation height: 0.5 to 1.2M from the ground.
2.Radar installation angle: the radar is fixed vertically to the ground.
3.Radar installation position: the radar is installed at the rear of the motorcycle, the radar signal surface corresponds to the rear of the motorcycle, the heat sink is on the top, and the cable outlet is on the bottom.
Before making the actual lane change, be sure to visually check the surrounding area. This system is only used to assist you in detecting the vehicles behind you when you change lanes. Due to certain limitations of the actual working environment, this system cannot be completely relied on.
Note:
It is recommended that the installation be carried out by professionals.
The installation angle of radar will affect the detection distance and effect. Please install it strictly according to the instructions.
Light shooting and different displays may cause the color of the item in the picture a little different from the real thing.
